3-6
Setup
k
Normal Mode Parameters
Tab Parameter Initial Default Range
[Sample] Sampling Interval 0.05 sec 0.0005 to 299 sec*
Number of Samples 100 10 to 30000
Warm-Up Auto Auto, Manual (1 to 999)
[Trigger] Start Trigger Tap Screen Tap Screen, Count Down, CH1, SONIC,
Microphone
* When one of the motion sensors is selected for the sensor, the setting range becomes 0.02
to 299 seconds.
• For details about each parameter, see “Parameters Common to All Modes” on page 3-5.
• Except for the [Tap Screen] item, all of the other start trigger options require specification of
additional parameters. For details, see “Additional Start Trigger Parameters” on page 3-9.
k
Real-Time Mode Parameters
Tab Parameter Initial Default Range
[Sample] Sampling Interval 0.3 sec 0.3 to 299 sec
Number of Samples 201 10 to 30000
Warm-Up Auto Auto, Manual (1 to 999)
[Trigger] Start Trigger Tap Screen Tap Screen, Count Down
• For details about each parameter, see “Parameters Common to All Modes” on page 3-5.
• Except for the [Tap Screen] item, all of the other start trigger options require specification of
additional parameters. For details, see “Additional Start Trigger Parameters” on page 3-9.
k
Fast Mode Parameters
Tab Parameter Initial Default Range
[Sample] Sampling Interval 20
애
sec 20
애
sec to 500
애
sec
Number of Samples 5000 10 to 30000
*
2
Warm-Up Auto Auto, Manual (1 to 999)
FFT Graph
*
1
On, Off
[Trigger] Start Trigger Tap Screen Tap Screen, Count Down, CH1, SONIC,
Microphone
*
1
See “FFT Graph” on page 3-7 for details.
*
2
When FFT Graph is turned on, the setting range become 10 through 8192.
• For details about parameters other than FFT graph, see “Parameters Common to All
Modes” on page 3-5.
• Except for the [Tap Screen] item, all of the other start trigger options require specification of
additional parameters. For details, see “Additional Start Trigger Parameters” on page 3-9.
Comments to this Manuals