Casio fx-CG500 User Manual download pdf (Page 76)

(7) Tap [OK].

• This outputs the waveform between the start point and end point from the EA-200’s

speaker.

• An error will result if the sound you configured cannot be output for some reason. Note

that the supported output range is 200 to 4000 Hz. If an error occurs, tap [OK] and then

perform the procedure from the beginning.

(8) To terminate sound output, press the EA-200 [START/STOP] key.

E-CON Graph Window Operations when Speaker (Sample Data) is

Selected (EA-200 only)

After a sampling operation while [CASIO] - [Speaker (Sample Data)] is selected as the

sensor, the calculator automatically graphs the sampled data on the E-CON Graph window.

This E-CON Graph window includes buttons that only appear when [Speaker (Sample Data)]

is selected:

, and

. These buttons can be used to horizontally stretch or compress

the graph, and to output sampled data to the speaker.

Tip

For details about [Speaker (Sample Data)] sampling parameters, see “2 Basic Steps for Configuring

Sampling Parameters”.

To output from the speaker after sampling

(1) Select [CASIO] - [Speaker (Sample Data)] as the sensor, and then perform sampling.

• The Speaker Output window shown to the right appears

after the sampling operation is complete. The sampling

results are graphed in the bottom of the window.

• On this screen, tapping

stretches the graph while

tapping

compresses it. Tapping the

button

returns to the E-CON Graph window.

(2) Tap

• This displays the Output Frequency dialog box.

(3) Specify the output frequency on the dialog box.

• Input a percent value for the output frequency value you want. To output the original

sound as-is, specify 100%. To raise the original sound by one octave, input a value of

200%. To lower the original sound by one octave, input a value of 50%.

9-14

E-CON Graph Window Operations

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 82 83

No comments

Casio fx-CG500 User Manual Page 76