Casio CTK710 User's Guide Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 48
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
E-16
Basic Operations
628A-E-018A
Percussion sounds
Example: 241 DRUM SET
This tone assigns various percussion sounds to the keyboard.
See the Percussion Instrument List on page A-5 for full
details.
Polyphony
The term polyphony refers to the maximum number of notes
you can play at the same time. The keyboard has 32-note
polyphony, which includes the notes you play as well as the
rhythms and auto-accompaniment patterns that are played
by the keyboard. This means that when a rhythm or auto-
accompaniment pattern is being played by the keyboard, the
number of notes (polyphony) available for keyboard play is
reduced. Also note that some of the tones offer only 16-note
polyphony.
NOTE
When rhythm or auto accompaniment is playing, the
number of sounds simultaneously played is reduced.
Using the Microphone Jack
Connecting a commercially available microphone to the MIC
IN jack makes it possible to sing along with the keyboards
built-in tunes. When connecting a microphone, be sure to first
adjust the MIC VOLUME to a relatively low setting, and then
adjust to the level you want after connecting.
1
Set the MIC VOLUME slider setting so it is on the
MIN side.
2
Turn on the microphones ON/OFF switch.
3
Use the MIC VOLUME slider to adjust microphone
volume to the level you want.
IMPORTANT!
Be sure to use the microphones ON/OFF switch to turn
off the microphone and to disconnect the microphone
from the keyboard whenever you are not using it.
Recommended Microphone Type
Dynamic microphone (standard plug)
IMPORTANT!
Be sure to disconnect the microphone from the keyboard
whenever you are not using it.
Howling (Feedback Noise)
Any of the following conditions can cause howling (feedback
noise).
Covering the head of the microphone with your hand
Positioning the microphone too near to a speaker
Should howling occur, try grasping the microphone further
away from the head, and move away from any nearby
speaker.
Static Noise
Fluorescent lighting can cause static noise in the microphone
signal. When this happens, move away from the lighting you
suspect may be causing the static.
MIC VOLUME slider
Microphone
Microphone ON/OFF switch
[Rear Panel]
CTK710_e_08-16.p65 06.1.23, 11:23 AM16
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Comments to this Manuals

No comments