Casio Cassiopeia PA-2400 User Manual download pdf (Page 31)

3.12 Details of Functions

FLCE /Y

< Description >

Used to set up the device, baud rate, and communication mode used for communication.

If this command is omitted, the default value {IrDA, 115200, } is used.

Any of the parameters can be omitted. If this is done, the default value for each parameter will

be used.

Always insert this command directly after FLCE. Placing it in another place will result in a

parameter error.

< Format >

FLCE /Y={ [<device>], [<baud rate>], [<mode>] }

(Parameters in [ ] can be omitted.)

< Parameter >

Device Select either "IrDA" or "COM1".

Baud rate If "IrDA" is selected - The following baud rates can be selected.

9600, 38400, 115200

(Irrespective of the selected baud rate communication at 9600 bps is allowed if

using the IrDA protocol.)

If "COM1" is selected - The following baud rates can be selected for RS-232C

communication.

9600, 19200, 38400, 57600, 115200

Combinations other than those described above are not permitted and will cause

a parameter error.

Mode "H" - H/PC-to-H/PC command specification mode (Connection-wait time-out

is 1 minute.)

This option is used by one side which specifies the operation command when

performing communication between two H/PCs.

(The FLCE on the communication partner H/PC should operate in the idle start

mode.)

"I" - Normal mode (Connection-wait time-out is infinite.)

Only "H" or "I" can be specified.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

No comments

Casio Cassiopeia PA-2400 User Manual Page 31