Casio DT-9721CHGE User's Guide download pdf (Page 7)

E-6

The Battery Charger can be used to charge the battery pack (DT-9723LIC).

1. Connect the power cable to the Battery

Charger, and then plug the cable into an

electrical outlet.

2. Attach the battery pack by sliding in the

direction indicated by the arrow. The

CHARGE indicator lamp (orange) lights

after a few seconds and charging begins.

Charging is completed when the CHARGE

indicator lamp goes out.

• Charging on completely discharged

battery pack takes about 3 hours.

• Time period of charging may vary

depending on the ambient temperature and condition of the battery pack.

• The CHARGE lamp flashes when battery pack already fully charged is attached

on the charger.

Important!

• Securely attach the battery pack to the Battery Charger.

• Charge the battery pack in a location that is free of vibrations.

• If the CHARGE lamp does not light at all or does flash when battery pack is

attached, it indicates the possibility of a malfunction either in the Battery Charger

or the battery pack. Please contact the store where you purchased the product or

an authorized CASIO service provider.

• Use only the power cord accompanied to the Battery Charger.

• For compliance in the USA and Canada, use only CSA/UL certified power cord

set, Polarized, Type SPT-2 or heavier, minimum No. 18 AWG copper, rated 125

or 250V, minimum 1A, minimum 6 ft (1.8m).

The power cord accompanied to the Battery Charger is compliant with this

requirement.

• With the Battery Charger, charge only the lithium-ion battery DT-9723LIC. It is

not recommended to use for other types of lithium-ion battery which may cause

burst.

Using the Battery Charger (DT-9721CHGE)

DT9721CHGE_E_P06_08.p65 09.11.12, 5:17 PM6

1 2 3 4 5 6 7 8 9 10

No comments

Casio DT-9721CHGE User's Guide Page 7