– 71 –
To send one data item
1. Display the data display (page 28) of the item you want to send.
2. Press FUNCTION and then select “Send record”.
3. Input a number 1 or 2 to select the model to which you want to send the data.
• A message appears asking if you are ready to send.
4. Press Y to start the send operation, or N to abort.
• To interrupt the send operation at any time, press ESC.
• After the send operation is complete, the display returns to the screen that was
on the display before you started the send operation. Then you can repeat the
above procedure to send another item.
To send all data items in specific modes
1. Press SHIFT FUNCTION and then select “Send all”.
2. Use Kand Lto move the pointer to the mode whose data items you want to
send, and then use Hand Jto change the setting.
• Data in modes set to “Yes” will be sent, while data in modes set to “No” will not.
3. Press ENTER.
4. Input a number 1 or 2 to select the model to which you want to send the data.
• A message appears asking if you are ready to send.
5. Press Y to start the send operation, or N to abort.
• To interrupt the send operation at any time, press ESC.
• After the send operation is complete, the display returns to the screen that was
on the display before you started the send operation.
Pointer (selected file)
Marker (current setting)
Comments to this Manuals