Casio PX410R User Manual download pdf (Page 92)

E-90

Troubleshooting

Problem Possible Cause Action See page

Nothing happens when the

LAYER or SPLIT button is

pressed.

No sound is produced when

playing MIDI data from a

computer.

Playing on the digital piano

produces an unnatural sound

when connected to a computer.

Cannot record chord

accompaniment data on a

computer.

The digital piano starts up

abnormally when it is turned

on.

A downloaded tone with

waveform contains noise or

digital piano operations become

abnormal when user data is

selected.

1. One or more of the melody

channels (2 through 4) is turned

off.

2. The volume setting of one or

more of the melody channels (2

through 4) is too low.

3. The digital piano is in record

standby.

4. The SMF Player Mode is currently

being use.

1. USB cable is not connected

properly.

2. Channel is turned off, or volume

setting is too low.

The computer’s MIDI Thru function

is turned on.

Accomp/Song MIDI Out is turned

off.

1. Flash memory is corrupted. There

is something wrong with the card.

2. The digital piano detected

abnormal flash memory data and

is automatically resetting the

digital piano system.

Someone may have turned off the

digital piano while data was being

stored in Flash memory or

something else has caused Flash

memory contents to become

corrupted for some reason.

1. Use the Mixer to turn on

Channels 2 through 4.

2. Use the Mixer to raise the volume

setting of Channels 2 through 4.

3. The LAYER and SPLIT buttons

are disabled during recording

and record standby.

4. Turn off the SMF Player Mode.

LAYER and SPLIT are not

available while the SMF Player

Mode is in use.

1. Connect USB cable properly.

2. Use the Mixer to turn the channel

on, or raise the volume setting.

Turn off the MIDI Thru function on

the computer or turn off Local

Control on the digital piano.

Turn on Accomp/Song MIDI Out.

1. a. Disconnect the AC adaptor and

press the POWER button.

b. Reconnect the AC adaptor, and

then press the POWER button

again to turn on power.

c. Use the TRANSPOSE/

FUNCTION button to perform

the system reset operation.

• If this does not solve the

problem, contact your

nearest authorized CASIO

Service Provider to request

repair.

2. Wait (about 40 seconds) until the

“Pls Wait” message disappears

from the display.

Use the TRANSPOSE/FUNCTION

button to perform the system reset

operation. If this does not correct

the problem, contact your nearest

authorized CASIO Service Provider

to request maintenance.

E-39

E-40

E-63, 64

E-72

E-78

E-39, 40

E-71

E-71

E-14

E-71

E-71

1 ... 91 92 93 94 95 96 97 98 99 100

Comments to this Manuals

No comments