Casio IT-3000 User Manual download pdf (Page 33)

E-31

A neck strap can be attached to the Handheld Printer Terminal to keep it from being

dropped while being carried. The stylus holder provided can also be attached.

Attach the neck strap following the

procedure described below.

Attachment Procedure

1. Pull out the neck strap mounting hooks

out of each silo on the bottom of the

Handheld Printer Terminal using the tip

of stylus. Hook the protrusive part (**)

of the ring on the neck strap mounting

hook as shown in the illustration. While

slightly pushing the ring, turn the ring

until all part of it is fully hooked.

** The ring is very stiff for the first time. A

small flat screw driver is helpful by

inserting it into overlapped part of the

ring to make a room when hooking the

protrusive part.

2. Pull back the locking bar of the neck

strap mounting hook and then hook the

mounting hook onto the ring as shown in

the illustration.

Neck strap

Adjust length here

Mounting

hooks

Stylus holder

Attaching the Neck Strap

The illustration shows the IT-3000M53E.

* ; The rings give an extra mechanical strength for

the Neck Strap. The metallic hooks of the Neck

Strap can, in rare case, be worn by abrasion

induced by swinging the IT-3000 terminal

specifically when it is hung from the operator's

neck with the Neck Strap. For those who often

use the IT-3000 terminal in a hanging position, it

is recommended to use the rings to secure the

Neck Strap.

Neck strap rings*

IT-3000_E_P16_32.p65 07.10.16, 15:1331

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 78 79

No comments

Casio IT-3000 User Manual Page 33