Casio KL-100 User Manual download pdf (Page 7)

E-6

Replacing Batteries

A handy low battery power indicator lets you know when battery power is get-

ting too low for proper operation. The message “BATT” appears on the display

if battery power is low when you perform any of the following operations.

• Turn power on

• Execute a print operation

Whenever the “BATT” message appears, press SET to clear it from the display.

You should still be able to perform some Label Printer operations, but some

power intensive operations (like printing) may become impossible if battery power

is too low. In any case, you should replace batteries as soon as possible or

switch to the AC adaptor as soon as possible after the “BATT” message ap-

pears.

Important!

• All data stored in memory is deleted whenever batteries go dead and when

you replace batteries. Be sure to keep written backup copies of all important

data (text and documents).

• Batteries can burst or leak and damage your unit if you do not use them

correctly. Note the following important points.

• Be sure that the plus (+) and minus (–) sides of each battery are facing cor-

rectly.

• Never mix batteries of different types

• Never leave dead batteries in the Label Printer.

• Remove the batteries if you do not plan to use the Label Printer for a long

time.

• Replace the batteries in accordance with the battery life marked on the side

of the battery.

Warning!

• Never use recharged batteries with the unit.

• Do not expose batteries to direct heat, do not short circuit them, and do not

try to take them apart.

•

Keep batteries out of the reach of small children. If swallowed, consult

with a physician immediately.

• Be sure to replace the batteries in accordance with the battery life printed on

the side of the battery itself.

To load the batteries

Caution

• Do not touch the springs inside the battery

compartment cover with your fingers while

loading or replacing batteries. The springs

have sharp areas and can cut your fingers.

1. Turn power off.

• If you are using the optional AC adaptor for power, you should also unplug it

from the Label Printer.

2. Turn over the label printer and remove the cover

as shown in the illustration.

3. Load batteries into the battery compartment.

• Be sure to use alkaline batteries.

• Make sure the positive (+) and negative (–)

ends of the batteries are facing correctly when

you load them.

4. Replace the back cover.

• As shown in the illustration, hook the cover

on the battery side of the compartment first,

and then close the cover.

• Make sure that the tape cartridge is securely

in place and that the back cover is closed

securely before using the label printer. A loose

tape cartridge can cause print quality prob-

lems.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments

Casio KL-100 User Manual Page 7

Comments to this Manuals

Related products and manuals for Printers Casio KL-100