Casio XJ-M141 Setup Guide User Manual download pdf (Page 14)

EN-12

Quick Guide

This section explains the operational flow up to the point that projection is started.

For more individual operations, see the “User’s Guide” (UsersGuide.pdf).

1. Load batteries into the remote controller.

☞ “To load remote controller batteries” (User’s Guide)

2. Place the projector onto a table, desk, or stand that is level and firm, making sure

that you allow enough room around it.

☞ “Setting Up the Projector”, “Setup Precautions” (User’s Guide)

z Also, be sure to read the “Safety Precautions” (page EN-1) and the “Operating Precautions” (page

EN-7).

3. Adjust the vertical angle of the

projector.

1 Lift up the front of the projector and press the

release button. This causes the front foot to

drop from the bottom of the projector.

2 While holding down the release button, raise

and lower the front of the projector. When the

front foot is the height you want, release the

release button. The front foot will lock at that

position.

3 Make fine adjustments to the horizontal tilt of

the projector by rotating the rear feet.

4. Use the supplied power cord to plug the projector into a power outlet.

5. Connect the projector to an image output device and then turn on the device.

☞ “Connecting Projector Cables” (User’s Guide)

6. Remove the projector lens cover.

7. Press the [P] (Power) key to turn on the projector.

z The first time you turn on the projector, a “Language” window will appear in the center of the

projection screen. Select the language you want.

8. Use the [INPUT] key to select the input source.

☞ “Selecting the Input Source” (User’s Guide)

9. Use the zoom ring of the projector’s lens to adjust the size of the projected image.

10.

Use the focus ring to adjust the focus.

11.

After you finish projecting, press the [P] (Power) key.

z This will cause a power down confirmation message to appear. Press the [P] (Power) key again

to turn off the projector.

NOTE

z This product is also designed for IT power distribution system with phase-to-phase voltage 230V.

2 1

1 ... 13 14 15 16 17 18 19 20 21 22

No comments

Casio XJ-M141 Setup Guide User Manual Page 14