Casio XJ-S31 - XGA DLP Projector User's Guide download pdf (Page 32)

User Maintenance

E-32

5. Loosen the three screws indicated by

an  mark.

6. Pull up on the handle or ribbon to

remove the lamp cartridge.

7. Insert the new lamp cartridge as far as

it will go, as shown in the illustration.

z After inserting the lamp cartridge, in the

case of a Type A lamp cartridge, lower

the handle towards the lamp. For a

Type B lamp cartridge, stow the ribbon

as shown in the illustration in step 5.

z Take care to avoid touching the lamp

(glass) and the mirrors inside the

projector. Doing so can cause the lamp

to rupture, shorten lamp life, and

otherwise affect lamp performance.

8. Secure the lamp cartridge with the

three screws.

9. Return the lamp cover to its original

position, and secure it with the screw.

z After replacing the lamp, be sure to

perform the procedure under “Resetting

the Lamp Time” on page E-32.

Resetting the Lamp Time

The lamp time reset operation you need to perform depends on when you replace the lamp.

If you replace the lamp when the above message appears, use the procedure under “To reset

the lamp time”.

If you replace the lamp after the above message appears, use the procedure under “To reset

the lamp time after exceeding the lamp life”.

Lamp cartridge

Make sure the grooves of the lamp cartridge

align with the grooves of the lamp housing.

It is time to replace the lamp. Use the procedure in the User’s Guide to replace the lamp as

soon as possible.

The lamp has exceeded its service life! The projector will not turn on until you replace the

lamp.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

No comments

Casio XJ-S31 - XGA DLP Projector User's Guide Page 32