Casio XJ-SK650 Setup Guide download pdf (Page 14)

Getting Ready

E-12

5. Perform the steps below to adjust the position and size of the Projector B image so

it slightly runs off the edges of the target screen, as shown in the “After adjustment”

image above.

z Take care simply to loosen the five screws. Do not remove them.

z After adjusting the position, re-tighten the fixing screws. Note that you will need to make fine

adjustments later in this procedure, so do not fully tighten the fixing screws at this point.

6. With both the Projector A and Projector B images being projected, repeat steps 3

and 5 as required to minimize the difference between the shape of the Projector A

and Projector B images.

Adjustment 2: Fine adjustment using the adjustment pattern

7. On the Control Box remote controller, press the [CORRECT] key.

(1) Adjust the zoom ring of Projector B.

(2) Loosen the five screws that secure the cabinet side panel, and then rotate the adjuster knob to

adjust the orientation.

Before adjustment After adjustment

Fixing screws Adjuster knob Fixing screws

XJ-SK650_Setup_e.book 12 ページ２０１３年１月２８日　月曜日　午後８時５分

1 ... 13 14 15 ... 56

No comments

Casio XJ-SK650 Setup Guide Page 14