Casio MPC-701 User's Guide Page 37

  • Download
  • Add to my manuals
  • Print
  • Page
    / 160
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 36
35
1
When the two battery packs are used for MPC-701, one of them can be
exchanged by the "hot swap" function at any time,even in the state of the
use MPC-701.
MPC-701 starts battery charge from a large remained capacity battery pack.
Please check the lamp color of BATT1 / BATT2.
When the battery pack under charge becomes full charge, charge of
the other battery pack is started.
Even if the battery pack of the waiting for charge is exchanged to
more remained capacity battery than the charging now,the target of
charge battery pack does not exchange.
Important
If the battery pack is attached to FIVA, do not unplug the AC
adapter until the
indicator lamp turns green (full charge). This
helps to extend battery pack life.
The battery pack requires period replacement. The end of a
battery pack’s service life is indicated when the battery pack
powers FIVA for a relatively short period after a full charge. When
this happens, replace the battery pack with a new one.
While the battery pack is being used or recharging, it may
become warm to the touch, this is not a malfunction but it just the
normal operation of the battery pack.
Locate the AC adapter power cord in a place where it will not be
tripped over.
When disconnecting the power cord from the power adapter port
on the FIVA unit, hold the connector and draw out straight.
If the power cord is connected to a power outlet for a long time,
the plug way become dusty. Clean the plug occasionally.
Note
See page 91 for information about battery pack life and charging
capacity.
Battery Indicator Lamp
Green
Amber
Red, even when chargin
Off during charge
Meaning
Full charge
Charging
Charging is disabled. Try charging again in an area
where temperature is within allowable range.
Charge the battery in the ambient operating environment
(0 to 40°C). The battery sometimes cannot be charged
in low or high temperatures even if charging is
performed within the ambient operating environment.
There is also a possibility of malfunction.
Charge was aborted. Remove battery pack from unit
and check it for external abnormality.
* When two battery packs are attached, only the lamp of
the battery pack being charged lights amber. The
lamp of the other battery pack does not light.
MPC701M50E#p23~35 02.11.22, 10:11 AM35
Page view 36
1 ... 36 37 38 ... 160

Comments to this Manuals

No comments