Casio PX-750 User Manual download pdf (Page 32)

E-30

Assembling the Stand

Remove the four screws (two on each end)

from back board

Attach side panels A and B to back board

C. Secure side panels A and B to the back

board

C using the screws you removed in

step 1.

• Attach the side panels so the side of the back panel C

where the joint connectors are inserted is facing

towards the back of the stand.

• If you have trouble inserting a screw into a joint

connector screw hole, use a screwdriver to adjust the

joint connector by rotating it.

3-1.

If you plan to locate the piano and stand

where it is not against a wall, you need to

extend the anti-tip brackets at the base of

side panels

A and B. Remove the two

screws (one on the outside of each side

panel) that hold the brackets, and then slide

the brackets as shown in the illustration. After

extending the anti-tip brackets, reinstall the

screws that secure them in place, but do not

tighten the screws fully at this time.

[Inside of side panels]

3-2.

If you plan to locate the piano and stand

against a wall, loosen the two screws (one on

the outside of each side panel) that secure

the brackets. You do not need to remove the

screws in this case.

• In this case, you do not need to remove the screws.

Just loosen them.

Joint

connectors

1 ... 31 32 33 ... 42

No comments

Casio PX-750 User Manual Page 32