Casio YA-W82M User's Guide download pdf (Page 29)

With each tap, a calibration mark will appear in the lower left, upper right, and

then lower right corners of the dot screen. Tap the center of each mark once

with the digital pen.

z Calibration is complete when you tap the fourth calibration mark.

To re-perform calibration

Perform the procedure under “To perform calibration”, starting from step 4. Even while calibration

marks are displayed, you can restart calibration by going back to step 4 under “To perform

calibration”.

Performing Calibration after Each Startup

You can configure IWB for CASIO to execute the calibration process whenever the dot screen is

tapped after startup. To do this, perform the steps below.

When this option is selected, the currently configured calibration information is discarded when you

exit IWB for CASIO. You should select this option if you frequently need to move the dot screen and/or

projector between presentations.

If there is no check mark next to “Perform calibration with each startup” (indicating that the option is

disabled, which is the initial default setting), calibration information produced by the last calibration

process is retained in memory. This means that tapping the dot screen will not start the calibration

process after you start up Interactive Whiteboard for CASIO.

Important!

z If the projector is not the computer’s primary display device, you will need to perform the

procedure under “To perform calibration” (page 28) as required, even if there is not check

mark next to the “Perform calibration with each startup” option.

1 Click the Interactive Whiteboard for CASIO icon ( ) in the computer’s task tray.

2 On the menu that appears, select “Perform calibration with each startup” so a check mark appears

next to it.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 88 89

No comments

Casio YA-W82M User's Guide Page 29