Casio EX-Z3000 User's Guide Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 145
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
18
Quick Start Basics
4. After charging is complete, disconnect the USB cable from the camera
and then unplug the adaptor from the power outlet.
. To charge using a USB connection to a computer
The battery loaded in the camera is charged whenever the camera is connected
directly to a computer with the USB cable.
Depending on the setup of your computer, you may not be able to charge the
camera’s battery over a USB connection. If this happens, use of the USB-AC
adaptor that comes with the camera is recommended.
IMPORTANT!
The first time you connect the camera to your computer with the USB cable, an
error message may appear on your computer. If this happens, disconnect and then
reconnect the USB cable.
1. Press [ON/OFF] (Power) to turn off the camera.
2. With your computer
turned on, connect the
camera to it.
The camera’s back lamp will
light red. After a short while,
the camera will turn on
automatically and the back
lamp will light amber to
indicate that charging has
started. The back lamp will
light green when charging is
complete. Note, however,
that some computer models
or connection conditions
can produce low supply
capacity. If low supply
capacity exists, charging will
start without the camera
turning on. This is indicated by the back lamp lighting red. The back lamp will go
out in this case after charging is complete.
It takes about 260 minutes to bring a fully dead battery to a full charge.
USB port
USB cable
(included with camera)
[USB/AV]
port
Large connector
Small connector
Making sure that the 6 mark on the camera is
aligned with the 4 mark of the USB cable
connector, connect the cable to the camera.
B
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 144 145

Comments to this Manuals

No comments