Casio KL-C500 User Manual download pdf (Page 46)

E-45

CANNOT

PRINT!

BAR CODE

MUST HAVE

EVEN NUMBER

OF DIGITS!

CANNOT PRINT!

NOT ENOUGH

DIGITS!

CANNOT

PRINT!

YOU ARE

USING ILLEGAL

CHARACTERS!

CANNOT

RECALL

MEMORY DATA

IN THIS MODE!

DATA ERROR!

RESET THE

LABEL

PRINTER!

GETTING

READY...

• Even number of dig-

its input for ITF bar

code when a check

digit is being used.

• Odd number of digits

input for ITF bar code

when a check digit is

not being used.

Bar code printed does

not have enough digits.

• Invalid characters

used in a bar code.

• Letter other than A,

B, C or D input for

CODABAR bar code

start code or end

code.

Attempt made to recall

barcode data as text.

• Corrupted or lost

memory contents

due to low battery

power.

• Attempting to save

text in memory be-

fore initializing

memory.

• Attempting to print

text before initializing

memory.

Printer is hot.

Message Possible Cause Action Page

E-43

E-43

E-43

E-36

E-8

E-29

• Add a 0 (zero) at the

first digit and re-input.

• Add a 0 (zero) at the

first digit and re-input.

Re-input with the

proper number of dig-

its.

• Change to allowed

characters.

• Use only the allow-

able characters.

Recall data as barcode

data in the PRESETS

menu.

Perform the reset op-

eration and try again.

Wait for a while. Print-

ing will resume when

temperature returns to

normal.

• If this problem hap-

pens often, try mak-

ing the print density

lighter (lower).

•

Using Labels

•

Data Communication

Messages

The messages in the following table are listed in alphabetical order.

Label will not adhere to a surface.

Possible Cause Action

Peel the backing paper from the back of the

tape to expose the adhesive.

Labels do not adhere well to surfaces that are

rough, wet, oily, or dirty.

Cannot transfer data.

Possible Cause Action

Make sure the data communication cable jacks

are connected securely.

Be sure to start actual data transfer within about

20 seconds after pressing SET to start a data

communication operation.

The backing paper is still

on the back of the tape.

Surface is unsuitable for

affixing a tape.

Poor data communication

cable connection

Passage of too much time

after setting up for data

communication

Message Possible Cause Action Page

CANCEL

FORMAT?

SET/ESC

CANNOT

INSERT!

• You changed the

number of lines.

• You specified char-

acter size (points) for

individual characters.

Recalling text into ex-

isting text results in

more than 511 charac-

ters or 16 blocks.

• To cancel preset for-

mat specification

press SET.

• If you do not want to

cancel the specifica-

tion, press ESC.

Reduce the number of

characters or blocks in

existing text.

E-23

E-15

E-25

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52

Comments to this Manuals

No comments