Casio DT-X30 R-50C User's Guide download pdf (Page 22)

E-20

Loading and Removing the Battery Pack

Your Handheld Terminal uses two types of battery: a battery pack and a memory

backup battery.

The battery pack is used to power normal operations and to store data, while the

memory backup battery (built-in) provides the power required to maintain memory

contents when the battery pack power is unable to supply power for some reason.

When the battery pack power goes low, immediately charge it or replace it with a

charged battery pack.

You can use either Dual Battery Charger, Cradle-type Battery Charger, USB Cradle,

or Ethernet Cradle to charge a battery pack. See the respective user’s guides for

information about how to charge.

Important!

Remaining capacity on a battery pack when you purchase it may be depleted

due to testing at the factory or natural discharge during shipment and storage.

Be sure to charge the battery pack before you use it.

The life of a battery pack is limited, and charging a battery pack causes it to

gradually lose its ability to maintain the charge. If your battery pack seems to

require charging very frequently, it probably means it is time to purchase a new one.

If a battery pack is used past the end of its service life, it may swell up in size. In

such a case, replace the battery pack with a new one.

When the battery pack is attached, it takes 30 minutes for the backup battery to

obtain enough charge for maintaining memory (RAM) contents for 10 minutes.

It takes four days for the backup battery to achieve a full charge.

Before replacing the battery pack, make sure that the power on the Handheld

Terminal is completely shut down.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 53 54

No comments

Casio DT-X30 R-50C User's Guide Page 22