Casio DT-X30 Series Specifications download pdf (Page 151)

151

State transition diagram

Note1: To perform cloning again in response to some setting change on the owner terminal once

backup data is transferred to a client terminal using this software, be sure to perform full

backup on the owner terminal, rather than partial backup.

Note2: After the owner terminal has became the P2P access point , that owner terminal can not

detect the late added client terminal whose Wi-Fi Direct enabled. In above case, the P2P

access point mode on the owner terminal should be disabled to detect such client terminal.

Initializing…

Searching client devices…

Connecting(1/N)

Connecting(2/N)

Waiting…

データ送信中…

Connecting (N/N)

Sending data…

：

Terminal bocomes Wi-Fi P2P access point.

Checking terminal that starting Copy Devices application.

(See Note 2.)

Connection process performs

sequentially. Wait about 30seconds per

one terminal.

At the time to connect with eight

terminals, stop connecting with other

terminals.

“N” is number of terminals on current

loop.

Retrieve the data from client terminal by

HTTP protocol. (Parallel processing)

If elapsed for about 1 minute after initialization, cancel P2P access

point and re-initialize.

Terminals

detected.

Zipping…

Archive all data under /mnt/sdcard

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 179 180

No comments

Casio DT-X30 Series Specifications Page 151