Casio EXILIM EX-ZR200 User Manual download pdf (Page 21)

Quick Start Basics

IMPORTANT!

• Charging is not performed while the connected computer is in the hibernate mode.

• A charging error can occur immediately after charging begins or some time after

charging begins. A charging error is indicated by the back lamp flashing red.

• If low supply capacity exists due to your computer model or connection conditions,

charging will start without the camera turning on. Turning on the camera in this

case will cause charging to stop and enter USB data communication between the

camera and the computer. The camera’s back lamp will be lit green at this time.

Other Charging Precautions

• With the two charging methods described above, you can charge the camera’s

battery (NP-130) without removing it from the camera. You also can charge the

battery using an optionally available charger unit (BC-130L). Never use any other

type of charger device. Attempting to use a different charger can result in

unexpected accident.

• A battery that is still warm immediately after normal use may not charge fully. Give

the battery time to cool before charging it.

• A battery discharges slightly even when it is not loaded in the camera. Because of

this, it is recommended that you charge the battery immediately before you need to

use it.

• Charging the camera’s battery may cause interference with TV and radio reception.

If this happens, plug the USB-AC adaptor into an outlet that is further away from

the TV or radio.

• Actual charging time depends on current battery capacity and charging conditions.

• Do not use the USB-AC adaptor with any other device.

Checking Remaining Battery Power

As battery power is consumed, a battery indicator on the monitor screen indicates

remaining power as shown below.

indicates battery power is low. Charge the battery as soon as possible.

Recording is not possible when is indicated. Charge the battery immediately.

• The level shown by the battery indicator may change when you switch between the

REC mode and PLAY mode.

• Leaving the camera for about 30 days with no power supplied while the battery is

dead will cause its date and time settings to be cleared. A message telling you to

configure time and date settings will appear the next time you turn on the camera

after restoring power. When this happens, configure date and time settings (page

164).

• See page 199 for information about battery life and number of shots.

Remaining Power High Low

Battery Indicator ***

Indicator Color Cyan * Amber * Red * Red

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 200 201

No comments

Casio EXILIM EX-ZR200 User Manual Page 21