Casio XJ-UT310WN Setup Guide download pdf (Page 55)

To change the computer IP address based on the projector’s IP

address and connect by wired LAN

Use a LAN cable to connect a computer directly to the projector.

Projector Operation

Select “Manual” for the projector IP setting.

(1) Perform the following steps to display the IP Settings dialog box: [MENU] key 3

“Network Settings” 3 “Projector Wired LAN Settings”.

z The initial default setting for “IP Settings” is “Auto”.

(2) Press the [X] key to select “Manual” for “IP Settings”.

z The projector IP address will be displayed in the “IP Address” line.

(3) Press the [ESC] key to return to “Network Settings”.

(4) Select “Update Network Settings” and then press the [ENTER] key.

(5) In response to the network setting update dialog box that appears, press the [S] key to

select “Yes” and then press the [ENTER] key.

Computer Operation

Specify an IP address for the computer. Octets 1, 2, and 3 should be the same as

those for the projector’s IP address. For Octet 4, specify a value in the range of 1

to 254, which is different from that of the projector’s IP address.

z For example, if the projector IP address 192.168.100.10 (which is its initial default), you should

specify a computer IP address of 192.168.100.XXX, where XXX is a value from 1 to 9, or 11 to

254.

Perform the operation starting from step 2 under “To log in to the Projector

Admin pages over a wired LAN connection” (page 54).

1 ... 54 55 56 ... 79

No comments

Casio XJ-UT310WN Setup Guide Page 55