Casio XJ-S30 - XGA DLP Projector User's Guide download pdf (Page 16)

Getting Ready

E-16

You can change the elevation angle of the projector in a range of 0 to 12 degrees. You can

also make fine adjustments to the left and right side elevation angle when necessary.

To change the projector elevation angle

1. Lift up the front of the projector and press the

release button.

z This causes the elevation adjustment foot to drop

from the bottom of the projector.

2. While holding down the release button, raise and

lower the front of the projector until the elevation

adjustment foot is approximately the length you

need.

3. Release the release button to lock the elevation adjustment foot in its current position.

4. Use the left and right adjustment feet to further fine adjust the elevation angle.

z To retract the elevation adjustment foot, hold down the release button and slide the

elevation adjustment foot back into the projector. Never try to forcibly change the elevation

adjustment foot position without pressing the release button.

In the case of rear projection, left/right orientation is opposite that of front projection, so you

need to configure the setup menu accordingly. For more detailed operation information, see the

User’s Guide (UsersGuide_English.pdf) on the CD-ROM that comes with the projector.

Adjusting the Projector Elevation Angle

Rear Projection (From the Back of the Screen)

Rotate to adjust horizontal alignment.

XJS30_S35_Kihon_E.book 16 ページ２００６年６月３０日　金曜日　午前１１時１３分

Downloaded From projector-manual.com Casio Manuals

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 36 37

No comments

Casio XJ-S30 - XGA DLP Projector User's Guide Page 16