Casio 3950P User's Guide download pdf (Page 41)

E-39

3. Press < to resume program execution.

u Program Execution Notes

•Pressing < after program execution finishes causes the same program

to be executed again.

•You can also run a program from the Run Prog screen by using number

keys 1 through 4 to specify a program number (P1 through P4). You

can display the Run Prog screen by pressing t < from the Edit Prog

screen after step 3 of the procedure under “Storing a Program” on page

36.

•You can use the following keys on the currently displayed value while

program execution is paused by the output command (^).

J, I, C, r, F*

*Note that you can use the F key to select the settings shown below

only. Program execution is automatically cancelled if you try to select any

other mode or setting.

Deg, Rad, Gra, Fix, Sci, Norm, Dec, Hex, Bin, Oct

•To cancel further program execution, press t.

u Errors During Program Execution

• If an error message appears on the display during program execution,

press the e or r key to automatically enter the Edit Prog Mode. The

location of the error with the cursor located there will appear on the

display at this time. Determine the cause of the error and edit the program

as required.

•Pressing the t key while an error message is on the display clears the

message and terminates program execution.

600.

Ans

The program number disappears after

program execution is complete.

(Area)

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 60 61

No comments

Casio 3950P User's Guide Page 41