Casio EX-TR200 User Manual Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 129
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
21
Quick Start Basics
. To charge using a USB connection to a computer
While the camera is turned
off, connect in the sequence
shown below (
1
,
2
).
If the camera is on, press
[ON/OFF] (Power) to turn it
off before connecting it to
your computer.
Charging time:
Approximately 260 minutes.
IMPORTANT!
The first time you connect the camera to your computer with the USB cable, an
error message may appear on your computer. If this happens, disconnect and then
reconnect the USB cable.
Some computer models or connection conditions can produce low supply capacity.
If low supply capacity exists, charging will start without the camera turning on. This
is indicated by the back lamp lighting red. The back lamp will go out in this case
after charging is complete.
A battery that has not been used for a long time or ambient temperature extremes
can cause charging to take longer than normal. If charging takes longer than about
six hours, a timer will terminate it automatically, even if the battery is not fully
charged. This is indicated by the back lamp flashing red. If the battery has not been
used for a very long time, charging may be terminated automatically and the back
lamp may start flashing red or go out after only about 30 minutes to 45 minutes. In
either case, use of the USB-AC adaptor that comes with the camera is
recommended.
Charging is not performed while the connected computer is in the hibernate mode.
If low supply capacity exists due to your computer model or connection conditions,
charging will start without the camera turning on. Turning on the camera in this
case will cause charging to stop and enter USB data communication between the
camera and the computer. The camera’s back lamp will be lit green at this time.
2
1
USB cable
(included with camera)
[USB] port
Making sure that the 8 mark on the USB cable
connector is towards the side opposite that of the
monitor screen, connect the cable to the camera.
Computer
(power turned on)
USB port
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 128 129

Comments to this Manuals

No comments