Casio PCR-T2100 Service Manual download pdf (Page 20)

— 18 —

5. DIAGNOSTIC OPERATION

5-1. To start the diagnostic program

1. First, be sure that MODE KEY is “OFF”. While holding down the “JFEED” button, turn MODE KEY to “PGM”.

When the “JFEED” button is released, the main display indicates as illustrated below.

RPT

AMOUNT

T1 T2 T3 T4

TOTAL CHANGE

INIT

2. Enter “99990000” and then press the “SUB TOTAL” button.

RPT

AMOUNT

T1 T2 T3 T4

TOTAL CHANGE

INIT

3. After DIAG version is printed out, DIAG mode starts.

B o o t V e r : 4 4 9 9 A

A p l i V e r : 4 5 0 1 A C

AGQA

BAFQA

RPT

AMOUNT

T1 T2 T3 T4

TOTAL CHANGE

DIAG

5-2. Notes for the DIAG

• To perform the continuous check, follow the direction for each test, and input numbers except 0. Input

numbers 1-9 as the command how many times to perform the test for the operation in each page to

perform continuous check. Note that you can only choose one time check or continuous check.

[Others]

• ESC value is printed as follows if the test ended by force. Press the “C” key or turn off the power to end

the test while performing continuous check. The result of ending by force is not printed in each test.

E S C

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 73 74

No comments

Casio PCR-T2100 Service Manual Page 20