Casio Cassiopeia EG-800 Specifications Page 48

  • Download
  • Add to my manuals
  • Print
  • Page
    / 89
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 47
— 45 —
8-4. Operation Check
8-4-1. How to enter into Operation Check Mode
It is recommended to perform FULL RESET with the
unit to delete the data saved in D-RAM before this
check.
To enter into this check Mode, perform the operation
described in item 18 of 8-2-1 or item 7 of 8-2-2 after
installation of diagnostic program.
Or, after the installation of diagnostic program by
8-2-1, press Contacts button over 3 seconds while
holding down Power button until below Operation
Check Main Menu appears.
If missed, try again.
After performing one of the operations described above,
the following Main Menu display for Operation Check
appears on the screen.
** Main Menu **
1 DISPLAY
2 TOUCH PANEL
3 MEMORY
4 SERIAL
5 POWER CONTROL
6 AUDIO
7 Others
8 COLOR BAR
9 VOLTAGE Write
Note: Generally, diagnostic program revision No. may be
changed without prior notice in future due to mass
production convenience.
AD Code = #####
CPROG Rev. 0.95 for Jx-590/597
Once the diagnostic program is installed to the unit, this program will be not deleted even if removing CF
card because this program has been installed in D-RAM assembled onto the main PC Board.
8-4-2. Operation Check
If the unit is locked during this check, enter into this check mode again after performing RESET
or FULL RESET operation.
8-4-2-1. Display Check
1. Tapping above 1 DISPLAY on the screen using a stylus, the red screen appears.
2. Tapping the screen, the green screen appears.
3. Tapping the screen again, the blue screen appears.
4. Tapping the screen again, the white frame display appears.
5. Tapping the screen again, the black frame display appears.
6. Tapping the screen again, no display appears.
7. Tapping the screen again, Main Menu display appears.
Page view 47
1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 88 89

Comments to this Manuals

No comments