Casio GRAPH90+ E User Manual download pdf (Page 609)

100

101

ε-28

Starting a Sampling Operation

9. Starting a Sampling Operation

This section describes how to use a setup configured using the E-CON4 mode to start a

Data Logger sampling operation.

k Before getting started...

Be sure to perform the following steps before starting sampling with a Data Logger.

1. Connect the calculator to a Data Logger.

2. Turn on Data Logger power.

3. In accordance with the setup you plan to use, connect the proper sensor to the

appropriate Data Logger channel.

4. Prepare the item whose data is to be sampled.

k Starting a Sampling Operation

A sampling operation can be started from the sampling screen or the setup memory list.

Here we will show the operation that starts from the sampling screen. See “To recall a setup

and use it for sampling” on page

ε-26 for information about starting sampling from the setup

memory list.

You need to perform a special operation in the case of Manual Sampling. For more

information, refer to “Manual Sampling” (page ε-31).

• To start sampling

1. Enter the sampling mode you want to use and then press 6(START).

• This displays a sampling start confirmation screen like the one shown below.

2. Press w.

• This sets up the Data Logger using the setup data in the current setup memory area.

• The message “Setting Data Logger...” remains on the display while Data Logger setup

is in progress. You can cancel the setup operation any time this message is displayed

by pressing A.

• The screen shown nearby appears after Data Logger

setup is complete.

1 2 ... 604 605 606 607 608 609 610 611 612 613 614 ... 633 634

Comments to this Manuals

No comments

Casio GRAPH90+ E User Manual Page 609

Comments to this Manuals

Related products and manuals for Water pumps Casio GRAPH90+ E