Casio EX-ZR50 Owner's Manual download pdf (Page 195)

195

Appendix

. If the camera’s back lamp starts flashing red...

If the back lamp starts flashing red during charging, it means that further charging is

not possible for one of the reasons below. Perform the actions described below to

correct the problem and then try charging again.

Ambient temperature or the temperature of the battery is abnormally high

or low

Unplug the USB cable from the camera and wait for a while until the camera is within

the temperature range of 15°C to 35°C (59°F to 95°F), and then try charging again.

Safety timer activated

A battery that has not been used for a long time, certain types of computers, and

connection conditions can cause charging to take longer than normal. If charging

takes longer than about 5 hours, a safety timer will terminate it automatically, even if

the battery is not fully charged. If the battery has not been used for a very long time,

charging may terminate automatically after only about 60 minutes.

1) Using a battery that has not been used for a long time.

Disconnect and then reconnect the USB cable to resume charging.

2) Insufficient power supply when connected to computer

The camera can be charged only via a USB 2.0 standard USB port. Connect

directly to a USB port what supplies a current of 500mA.

For details about the power supply capacity of a computer’s USB port, contact the

manufacturer of the computer. Though disconnecting and then reconnecting the USB

cable will resume charging, you may need to do so repeatedly if the power supply

capacity of the computer is low.

Power Supply

Charging

If problems persist after you perform the above steps or if the battery fails to

charge after 5 hours, it could mean that the battery is faulty. Contact your nearest

CASIO authorized service center.

1 ... 194 195 196 ... 215

No comments

Casio EX-ZR50 Owner's Manual Page 195