E-51
Connecting the AC Adaptor and Connecting to Computer
Use the AC adaptor sold separately from the Bridge Satellite Cradle/Bridge Basic Cradle
for the power supply of the Bridge Satellite Cradle/Bridge Basic Cradle. Always make
sure that the power is being supplied to the Bridge Satellite Cradle by the AC adaptor
before performing any type of data communication operation with the Handheld
Terminal. The Handheld Terminal draws the power via the Bridge Satellite Cradle/
Bridge Basic Cradle during data communication.
1. After making sure that the Bridge Satellite
Cradle/Bridge Basic Cradle power switch
is turned off, plug the AC adaptor into the
AC adaptor jack on the back.
2. Next, plug the AC adaptor into a power
outlet.
3. After making sure that the Bridge Satellite
Cradle/Bridge Basic Cradle and your
computer are both turned off, remove the
cap from the Bridge Satellite Cradle/
Bridge Basic Cradle connection ports, and
then perform one of the following steps to
connect to your computer.
Be sure to keep the Bridge Satellite Cradle/
Bridge Basic Cradle connection ports
covered whenever you are not using them.
RS-232C Connection
• Connect an RS-232C cable (DT-
887AXA) to the RS-232C port (HA-
A61IO only) of the Bridge Satellite
Cradle. Connect the other end to your
computer’s RS-232C port.
USB Connection
• Connect a USB cable (DT-380USB) to
the USB port of the Bridge Satellite
Cradle/Bridge Basic Cradle. Connect
the other end to your computer’s USB
port.
4. Turn on the power. This causes the Bridge
Satellite Cradle/Bridge Basic Cradle
power indicator lamp to light in red.
Power switch (OFF)
When using the USB port
POWER D ATA LINE
System Status Indicator Lamp
Power Indicator Lamp
Communication Indicator Lamp
(HA-A61IO only)
Power switch (ON)
Power
contacts
DT-X5_E_P49_58.p65 04.7.14, 6:05 PM51
Comments to this Manuals