Casio XJ-450 User's Guide download pdf (Page 118)

118

User Maintenance

5. Press the [S] key to select “Ye s ”, and then press the [ENTER] key.

z This resets the lamp time to 0 hours.

6. Press the [MENU] key to exit the setup menu.

z This causes the setup menu to disappear from the projected image.

To reset the lamp time after exceeding the lamp life

If you use the existing lamp until its life is exceeded, you will not be able to turn on the

projector even after you replace the lamp with a new one. Perform the following procedure to

initialize the lamp time in this case, which will make it possible to turn on the projector.

1. Use the bundled AC power cord to plug the projector into a power

outlet.

z Connecting to a power outlet causes the POWER/STANDBY and LAMP indicators on

the top of the projector to light red, which indicates that the lamp has exceeded its

service life.

2. While holding down the projector’s [W] key, hold down the [AUTO] key

for about five seconds.

z This will reset the lamp time, cause the POWER/STANDBY indicator to change from red

to amber, and also cause the LAMP indicator to go out.

3. Press the [ ] (power) key to ensure that the projector turns on

normally.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 129 130

No comments

Casio XJ-450 User's Guide Page 118