Casio XJ-450 User's Guide download pdf (Page 47)

Projection Operations

Auto Input Source Selection

When you turn on the projector, it checks the status of each input source (whether or not

the input source is sending a signal) in the sequence shown below. It automatically selects

the first input source it finds that is sending an input signal, and projects the applicable

image.

If the RGB input terminal is connected to a computer and the S-VIDEO input terminal is

connected to a video deck and signals are being supplied by both, for example, the projector

automatically selects RGB input when it is turned on. The currently selected input source

name is shown in the upper right corner of the projection screen.

z If the projector does not find any input signal, the message “No signal input” appears in

place of the input source name.

z Whether the displayed input source name shows [RGB] or [Component] depends on the

current “Input Settings J RGB Input” (page 89) setting that is configured on the

projector’s setup menu.

For information about configuring setup menu settings, see “Using the Setup Menu” on

page 64. For information about component video, see “Connecting to a Component Video

Output Device” on page 40.

z Note that the projector does not select the input source automatically when “Off” is

selected for the “Option Settings1 J Auto Input Detect” (page 92) setting on the setup

menu.

If the input source name shows this: It means this input is selected:

RGB RGB

Component Component video

RGB terminal input

VIDEO terminal input

S-VIDEO terminal input

(RGB/Component)

(VIDEO)

(S-VIDEO)

Input source name

RGB

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 129 130

No comments

Casio XJ-450 User's Guide Page 47