Casio XJ-UT310WN Setup Guide download pdf (Page 56)

To change the projector’s IP address based on the computer’s

IP address and connect by wired LAN

Note

z Use the procedure below when you know the computer’s IP address.

Use a LAN cable to connect a computer directly to the projector.

Specify the projector’s IP address manually.

(1) Perform the following steps to display the IP Settings dialog box: [MENU] key 3

“Network Settings” 3 “Projector Wired LAN Settings”.

z The initial default setting for “IP Settings” is “Auto”.

(2) Press the [X] key to select “Manual” for “IP Settings”.

(3) Use the [T] key to select “IP Address” and then press the [ENTER] key.

z This will display the Input IP Address dialog box.

(4) Use the [W] and [X] keys to change Octet 1 of the IP address so it is the same as the

computer’s IP address After the setting is the way you want press the [T] key.

(5) Repeat step (4) to specify Octets 2 through 4.

z Octets 2 and 3 should be the same as those of the computer’s IP address.

z Octet 4 should be a value in the range of 1 to 254, and different from Octet 4 of the

computer’s IP address.

(6) Press the [ESC] key to return to “Network Settings”.

(7) Select “Update Network Settings” and then press the [ENTER] key.

(8) In response to the network setting update dialog box that appears, press the [S] key to

select “Yes” and then press the [ENTER] key.

Perform the operation starting from step 2 under “To log in to the Projector

Admin pages over a wired LAN connection” (page 54).

1 ... 55 56 57 ... 79

No comments

Casio XJ-UT310WN Setup Guide Page 56