Casio KL-820 - Label Printer User's Guide download pdf (Page 12)

E-11

6. Load the tape cartridge into the Label Printer, making sure that the tape and

ink ribbon pass between the head and roller.

7. Close the cover.

8. Turn on Label Printer power and press FUNC and then

– (FEED) two or

three times to make sure that the tape comes out without any problem.

• If the tape does not come out normally, turn off power and start again from

step 1 above.

3. Remove the stopper from a new tape cartridge and check to see that the

tape is ready to use.

• Make sure that the tape is under the tape guide and that it is not bent or

twisted.

4. Pull the tape out about 3cm.

Important!

• Once tape is pulled out, there is no way to get it back into the cartridge.

• Never use excessive force when pulling on the tape. Doing so can cause the

ink ribbon to break, creating the risk of malfunction.

5. Use a pencil or some other thin object to take

up slack in the ink ribbon as shown in the

illustration. Note that the tape does not move at

this time.

• If the ink ribbon is slack when you load it into the

Label Printer, it can break or cause some other

problem.

• Be sure to turn the ink ribbon take up spool only

in the direction indicated by the arrow (a).

• Turn the spool until the other spool (b) starts

turning in the direction noted by the arrow. This

indicates there is no slack in the ribbon.

(a)

(b)

NO!

OK!

Tape guide

Tape

Ink ribbon

(under the tape)

Roller

Head

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 44 45

No comments

Casio KL-820 - Label Printer User's Guide Page 12