Casio GRAPH90+ E User Manual download pdf (Page 600)

100

101

ε-28

Starting a Sampling Operation

9. Starting a Sampling Operation

This section describes how to use a setup configured using the E-CON4 mode to start a

Data Logger sampling operation.

k Before getting started...

Be sure to perform the following steps before starting sampling with a Data Logger.

1. Connect the calculator to a

Data Logger.

2. Turn on

Data Logger power.

3. In accordance with the setup you plan to use, connect the proper sensor to the

appropriate

Data Logger channel.

4. Prepare the item whose data is to be sampled.

k Starting a Sampling Operation

A sampling operation can be started from the sampling screen or the setup memory list.

Here we will show the operation that starts from the sampling screen.

See “To recall a setup

and use it for sampling” on page ε-26 for information about starting sampling from the setup

memory list.

• To start sampling

1. Enter the sampling mode you want to use and then press 6(START).

• This displays a sampling start confirmation screen like the one shown below.

2. Press w.

• This sets up the

Data Logger using the setup data in the current setup memory area.

• The message “Setting

Data Logger...” remains on the display while Data Logger setup

is in progress. You can cancel the setup operation any time this message is displayed

by pressing A.

• The screen shown nearby appears after

Data Logger

setup is complete.

1 2 ... 595 596 597 598 599 600 601 602 603 604 605 ... 621 622

Comments to this Manuals

No comments

Casio GRAPH90+ E User Manual Page 600

Comments to this Manuals

Related products and manuals for Water pumps Casio GRAPH90+ E