Casio KL-750 User Manual download pdf (Page 17)

E-16

To initialize the Label Printer

1. Turn power off.

2. While holding down the PRINT and ESC keys,

press ON to turn power on.

3. Keeping PRINT and ESC held down, release

the ON key only.

• This prompt confirms whether or not you want to

initialize the Label Printer.

4. Press SET to initialize the Label Printer or ESC to abort the reset operation.

• The following table shows the initial settings.

Troubleshooting

INT?

Action

• Use only one ¥ mark.

Only two lines of text

can be input, so text

can contain only one

¥ mark.

• Do not use ¥ marks.

6mm tape can have

only one line of text,

so text cannot contain

any ¥ marks.

• Delete the ¥ mark to

print on 6mm tape or

switch back to a wider

tape.

• Shorten the text to be

printed and try again.

• Change the tape width

setting to OFF and try

printing the stamp

again.

• Delete text from one of

the text memory areas

and then store the new

text.

• Replace batteries.

• Initialize the Label

Printer.

Problem

ERR! message

on the display.

FUL! message

on the display.

BATT message

on the display.

ERR! message

on the display.

Possible Cause

• Attempt to input two ¥

marks within the same

text.

• Attempt to input ¥

mark while 6mm is

specified as the tape

width.

• Label text containing a

¥ mark was input and

then tape width

specification was

changed to 6mm.

(ERR! message appears

when you try to perform

a print operation.)

• Text that is longer than

5.5cm when stamp

printing is selected.

• Attempt to print a stamp

while 6mm is specified

for the tape width.

• Both text memory areas

(AREA 1 and AREA 2)

already contain text.

• Battery power is too

low.

• Memory data has

become corrupted for

some reason.

Item

Display

Memory

SYMBOL

EFFECT

M-FEED

MIRROR

MEMO

DENSITY

WIDTH

Reset

Cleared

Cleared

,

CANCEL

NO

OFF

STR?

3

OFF

1 ... 16 17 18 19

Comments to this Manuals

No comments