Casio XW-G1 User's Guide download pdf (Page 38)

Selecting and Creating Tones

E-36

When the

HOLD button is lit (by pressing it), the currently

sounding note or arpeggio (page E-40) will be sustained.

• Pressing

HOLD again will cause its light to go out,

indicating that hold is turned off.

You can use the

TRANSPOSE and OCTAVE (–, +)

buttons to change the pitch of the keyboard notes in

semitone or octave steps.

• For information about fine tuning the pitch in hertz steps

(Tuning), see page E-81.

To change the pitch in semitone steps, hold

down

TRANSPOSE as you press the

OCTAVE minus (–) or plus (+) button.

• The setting range for this operation is one octave

upwards and downwards (–12 semitones to +12

semitones).

To change the pitch in octave steps, use the

OCTAVE minus (–) and plus (+) buttons

(without holding down

TRANSPOSE).

• The setting range for this operation is three octaves

upwards and downwards (–3 octaves to +3 octaves).

• While the setting screen shown above is displayed you can

the

dial or the

minus (–) or plus (+) buttons to

change the setting. If you do not perform any operation for

a while, the setting screen will be exited automatically.

You can apply reverb, vibrato, and other effects to notes to

enhance their sound.

■ Effect Block Diagram

Using the Hold Button

Changing the Pitch of Notes in Semitone

Steps (Transpose) or Octave Steps (Octave

Shift)

Lights when HOLD is on.

Applying Effects to Notes

Sound

Source

(5) Master

Equalizer

Goes through (2), (3),

or (4). Also refer to

the “Chorus and DSP

Use Restrictions”

below.

Output

(1) Reverb

(2) Chorus

(3) Normal DSP

(4) Solo

Synthesizer

DSP

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 107 108

Comments to this Manuals

No comments

Casio XW-G1 User's Guide Page 38

Comments to this Manuals

Related products and manuals for Synthesizer Casio XW-G1