Casio XW-G1 User's Guide download pdf (Page 44)

Sounding Arpeggios Automatically

E-42

Use the

dial or the

minus (–) and plus (+) buttons to change the TYPE, NOTE, and VELO settings.

• You can also use the

1 to 16 buttons to toggle each step on or off.

•While TYPE is selected, use the

minus (–) and plus (+) buttons to turn the TYPE setting on or off.

• You can use

(eight sliders excluding “MASTER”) to change the values of the applicable step directly. When using the

sliders, press

1-8/9-16 to toggle between steps 1 through 8 (button unlit) and steps 9 through 16 (button lit). Note,

however, that you will not be able to use the sliders when TYPE is TIE and OFF.

• You can specify the tie setting. For details how, see “To configure tied note settings” on page E-53.

• The table below shows the contents of the arpeggio step editing menu.

After the TYPE, NOTE, and VELO settings are the way you want, press

EXIT to return to the arpeggio

menu screen.

Use the

up (q) and down (w) buttons to move the item selection cursor (0) to “Parameter”, and

then press

ENTER.

Menu Layer

Description Settings

1 2

Step Edit >Ent

TYPE

Specifies the relative position in the arpeggio pattern where the keyboard notes will play starting

from the lowest note played (which is L1).

• If the number of keys pressed is less than the number of configured type (L) settings (i.e. if you

press only three keyboard keys for an arpeggio pattern that includes settings for L1 through L6),

the arpeggio pattern will repeat, playing the keyboard key notes one octave higher.

• At any point the above causes the range of one higher octave to be exceeded, arpeggio play will

return to the L1 note automatically.

L1 to L8

Specifies the relative position in the arpeggio pattern where the keyboard notes will play starting

from the highest note played (which is U1).

• If the number of keys pressed is less than the number of configured type (U) settings (i.e. if you

press only three keyboard keys for an arpeggio pattern that includes settings for U1 through

U6), the arpeggio pattern will repeat, playing the keyboard key notes one octave lower.

• At any point the above causes the range of one lower octave to be exceeded, arpeggio play will

return to the U1 note automatically.

U1 to U8

Specifies how many of the notes played on the keyboard, starting from the highest note played,

should be played simultaneously.

• When the number of keys pressed is less than the polyphony (P) value specified here, only the

notes that are played are sounded.

P2 to P5

NOTE Shifts the notes produced by pressing keys in semitone steps. –24 to +24

VELO Changes the velocity of pressed keys. –64 to +63

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 107 108

Comments to this Manuals

No comments

Casio XW-G1 User's Guide Page 44

Comments to this Manuals

Related products and manuals for Synthesizer Casio XW-G1