Casio XW-G1 User's Guide download pdf (Page 43)

Sounding Arpeggios Automatically

E-41

Select arpeggio hold or synchro ON/OFF.

• If you want to turn on the hold function (HOLD), press

STEP +. Each press toggles HOLD between on and

off.

• If you want to turn on the sync function (SYNC), use

STEP – to cycle through the available sync settings

described below.

• The HOLD and SYNC settings are performance

parameters.

Press some keys and the arpeggio will start to

play automatically.

• To turn off the Arpeggio Function, press

ARPEGGIO again.

• To stop arpeggio HOLD playback, press

ARPEGGIO or change the HOLD function in step 2 of

the above procedure to OFF.

■ You can use the arpeggio type selection screen

to select the recommended tone for the currently

selected arpeggio type as your Zone Part 1 tone.

Hold down

ARPEGGIO until the arpeggio

type selection screen appears on the display.

Hold down

EDIT until

ARPEGGIO starts

to flash and then stops flashing to remain lit.

• In the case of a user arpeggio, the tone that was

selected as the Zone Part 1 tone when the user data

was saved is the recommended tone.

There are two arpeggio types: step type and variation type.

• With a step type arpeggio, you can edit its steps and its

parameters. A step type arpeggio can contain up to 16

steps. You can change the following values for each step.

• With a variation type arpeggio, you can edit only its

parameters.

Hold down

ARPEGGIO until the arpeggio

type selection screen shown below appears on

the display.

From among the preset or user arpeggio types

select the arpeggio type you want to edit.

• For information about how to select an arpeggio type,

see steps 2 through 5 under “To use the Arpeggio

Function” (page E-40).

Press

EDIT.

Use the

up (q) and down (w) buttons to

move the item selection cursor (0) to “Step

Edit”, and then press

ENTER.

• The “Step Edit” option will not be displayed if you

selected a variation type arpeggio in step 2 above.

OFF : The arpeggio will play while keyboard keys are

depressed.

ON : The arpeggio will continue to play even after the

keyboard keys are released

OFF : Sync setting is turned off.

ON : Arpeggio play is synced with only the play

operation of the Step Sequencer.

S/S : Arpeggio play is synced with both the play and

stop operations of the Step Sequencer.

Editing an Arpeggio

TYPE : Specifies the relative position in the arpeggio

pattern where each of the keyboard notes will play.

You can specify positions starting from the lowest

note played (L1) or from the highest note played

(U1). You can even specify simultaneous play of up

to five notes (P2 through P5).

NOTE: Specifies a relative shift, in semitone steps, from

the note played on the keyboard.

VELO : Specifies the volume of the note.

Step type

Step number

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 107 108

Comments to this Manuals

No comments

Casio XW-G1 User's Guide Page 43

Comments to this Manuals

Related products and manuals for Synthesizer Casio XW-G1