Casio EX-FC200S User Manual download pdf (Page 19)

Quick Start Basics

4. After charging is complete, disconnect the USB cable from the camera

and then unplug the power cord from the power outlet.

. To charge using a USB connection to a computer

The battery loaded in the camera is charged whenever the camera is connected

directly to a computer with the USB cable.

• Depending on the setup of your computer, you may not be able to charge the

camera’s battery over a USB connection. If this happens, use of the USB-AC

adaptor that comes with the camera is recommended.

IMPORTANT!

• The first time you connect the camera to your computer with the USB cable, an

error message may appear on your computer. If this happens, disconnect and then

reconnect the USB cable.

1. Press [ON/OFF] (Power) to turn off the camera.

2. With your computer turned on, connect the camera to it.

The camera’s back lamp will light red. After a short while, the camera will turn on

automatically and the back lamp will light amber to indicate that charging has

started. The back lamp will light green when charging is complete. Note,

however, that some computer models or connection conditions can produce low

supply capacity. If low supply capacity exists, charging will start without the

camera turning on. This is indicated by the back lamp lighting red. The back lamp

will go out in this case after charging is complete.

USB port

USB cable (included with camera)

Making sure that the 6 mark on the camera is aligned

with the 4 mark of the USB cable connector, connect

the cable to the camera.

[USB/AV] port

Large connector

Small connector

Terminal

cover

1 ... 18 19 20 ... 195

No comments

Casio EX-FC200S User Manual Page 19